Hi, I’ve created a yaml config file for the following config: Venitlation unit (in my case a Storkair WHR 930), controlled via a Perilex Plug Old-fashioned 3-level switch to control the ventilation unit Shelly 2.5 to controll/influence the 3-level switch These ventilation units are controlled relatively simple: -when L1 is live/hot, the ventilation unit goes to medium -when L2 is live/hot, the ventilation unit goed to high -when L1 and L2 are not live, the ventilation unit goes to low -i
24 VDC 3 wire ball valve with Shelly 2.5 - Configuration - Home Assistant Community
Ventilation: Shelly 2.5 with 3-level switch - ESPHome - Home Assistant Community
Shelly 2.5 high temperature? - Hardware - Home Assistant Community
Which smart switch is needed? - #24 by stevemann - Hardware - Home Assistant Community
Shelly fan control, or Why my bathroom light switch now has two IP addresses… - Share your Projects! - Home Assistant Community
Shelly 2.5: Flash ESPHome Over The Air!
Shelly 2.5: Flash ESPHome Over The Air!
Shelly 2.5: Flash ESPHome Over The Air!
Which smart switch is needed? - #24 by stevemann - Hardware - Home Assistant Community
ESP Conrol Brinks WTW - Let's Control It
Shelly 2.5 Binary Sensors not recognizing state change - ESPHome - Home Assistant Community
Shelly 2.5: Flash ESPHome Over The Air!
Shelly 2.5 getting hot to touch (63°C external case) - should I be worried? - Hardware - Home Assistant Community
Shelly 2.5 getting hot to touch (63°C external case) - should I be worried? - Hardware - Home Assistant Community
Shelly 2.5 gets stuck in a overheat state until Restart - ESPHome - Home Assistant Community